Making a semi-masculine, rustic-looking wood plank headboard is very easy.
Dean and I should know, we've created one in each of our last two houses!
Just grab a few wood pallets, dismantle them, sand down the pieces then follow our instructions below and you'll have the perfect rustic wood headboard in a weekend!
And if you don't have any wood pallets kicking around, you can actually use new wood stained to look old – which is actually what we did!
Since we built this wood headboard in our last house and our current house in rooms in which we wanted to maximize space, we did this headboard the really easy way.
How to Make a Wood Plank Headboard
First you need to decide how big to make the headboard. Since we have a queen bed, we decided on five feet wide by almost six feet tall. No rhyme or reason really. Just the approximate width of the bed and slightly taller than the width for height.
- palm sander OR sandpaper and some muscles
- stud finder
- wood (we used twelve 1″ x 6″ x 8′ pieces of spruce and had Home Depot cut them all down to 5′ long.)
- 2″ screws (flat-head)
- old rag
- Minwax stain in Special Walnut
1. Whether you use new wood or wood from pallets, after cutting PLEASE sand the boards. You don't want any splinters or rough spots in your headboard!
2. In a well-ventilated room and perhaps wearing a mask (trust me, this stuff STINKS when wet!), rub the minwax stain into the wood. Wipe off excess with a clean, lint-free rag. I only did one coat, but if you would like it darker feel free to stain again. Let stain dry thoroughly!
3. Decide where to put your headboard. Find the studs. Mark vertical stud lines with a pencil.
3. Starting at the bottom (@ baseboard or floor), screw the first board to the wall using the stud marks (and painter's tape box) you made in Step 3. If it helps you visualize and place boards, mark the outline of your headboard with painter's tape first. Continue stacking the boards one on top of the other and fastening in this way all the way to the top (last) board.
See, didn't I tell you it was easy?!
And it was inexpensive!
Here's our cost breakdown:
- The wood was $2.97 per 8 foot length. That was the shortest the HD had. Times twelve boards = $36.
- We had the stain. But if you were to buy it I think it's about $9 for the small container. I used half that. Effectively $4.50.
- I had to buy screws because somehow in our buckets of hardware we had no 2″ flat head screws. Go figure. $6.