You have all been so patient!
Since we posted the reveal of our Restoration Hardware Inspired DIY Brickmaker's Coffee Table, a few of you have emailed and messaged asking when the DIY post would be up.
Well, here it is!
Better late than never, right?
My hubby Dean works in sheet metal for those of you who are new around here. BUT for this coffee table we wanted to come up with a metal-looking option that didn't actually require metal, or your very own sheet metal worker!
So our table is made entirely of wood – legs and all!
DIY Brickmaker's Coffee Table
- 4 – 2″x6″x8′ pine
- 2 – 2″x2″x8′ pine
- 2 – 2″x2″x8′ pine
- 1 – 2″x2″x4′ pine
- 4 – 3/8″ plated hex bolts, 1 1/2″ long
- finishing nails
- #8 flathead screws 2 1/2″ long
- dark walnut stain
- white paint
- grey stain
- Rustoleum Metallic Accents paint in rich brown
- 8 – 2″x6″x45″ pine (table top)
- 4 – 2″x2″x45″ pine (top and bottom of frame)
- 4 – 2″x2″x42″ pine (top and bottom of frame)
- 4 – 2″x2″x11″ pine (legs)
- measuring tape
- compound miter saw
- drill & drill bits
- 7/8″ spade bit
- paint brushes
1. Once your materials are cut to size, build two squares from the 2″x2″x43″s and 2″x2″x45″s. Simply nail together with finishing nails and hammer. This will be the top and bottom of the “metal” frame.
2. Add vertical pieces (legs) as shown below, also affixing with nails.
3. Begin adding top pieces as shown, adding screws from bottom so they aren't seen. Leave 1/8″ between each board.
4. To add hex bolts, after assembly pre-drill 1/8″ holes into tabletop's side 12 1/2″ from end. Repeat at other end. Repeat for two holes on opposite side. This is to guide the larger holes. Using spade bit centered on 1/8″ holes, drill 1/2″ depth to sink hex bolt. Then using 3/8″ drill bit, pre-drill the bolt hole. See photo below.
The finish on this table is what makes it extraordinary, in my opinion. The legs are painted to look like metal and the top is coated with several layers of stain and white/grey washes.
1. Paint base and legs with Rustoleum Metallic Accents paint in rich brown. Apply two coats if necessary. Let dry.
2. Dark stain the table top using the dark walnut. Let dry.
3. Apply a coat of grey stain. Let dry.
4. Mix about a tablespoon of white paint into about a 1/2 cup of water. Use this to white wash over the stained table top boards. Let dry. Repeat steps 2-4 if desired as I did a few times for many layers of stain/paint.
And that is – finally – the DIY Brickmaker's Table tutorial!
Free DECORATING 101 Course
JOIN OVER 7,751 SUBSCRIBERS WHO ARE LEARNING EXACTLY WHERE TO START AND HOW TO CONFIDENTLY DECORATE THEIR OWN HOMES - AND GET THE 'DECORATING 101' COURSE FOR FREE!